Fixture Installation
Services list
Fixture installation and repair in Universal City for faucets, toilets, and showers
Fixture leaking or won’t shut off? Call (726) 227-0988 and we’ll get it sorted out.
A faucet that drips all night, a toilet that rocks when you sit, a shower that swings from hot to cold: none of these are emergencies, but they waste water and get worse. Universal City Plumbing Solutions handles faucet repair, toilet installation, shower valve replacement, and sink installation in houses, townhomes, and condos. A plumber checks the shutoff valves and the supply lines behind the fixture too, so your new faucet isn’t sitting on a valve that won’t close next time you need it.
Why Choose us
Reasons why you should choose us
On time every time
Clear repair options
Respect for your home
Trained plumbers
What hard water does to faucets and valves
Universal City’s water runs around 15 grains per gallon. Those minerals collect inside faucet cartridges, shower valves, and toilet fill valves, so handles get stiff, drips start early, and aerators clog. It’s also why older shutoff valves under sinks often won’t turn when you finally need them.
Fixture problems we take care of
Faucet repair
Most drips come from a worn cartridge, washer, or seat. If the faucet body is corroded or parts aren’t available anymore, replacing the whole faucet often makes more sense.
Toilets that run, rock, or leak
A running toilet usually needs a new flapper or fill valve. A toilet that rocks or leaks at the base needs to come up so we can check the wax ring and the flange underneath.
Shower valves that can’t hold temperature
Scale and worn parts inside the mixing valve cause temperature swings. We repair the cartridge when we can and replace the valve behind the wall when we can’t.
Stuck stops under sinks and toilets
A plumber sees this one constantly. Older stop valves under sinks and behind toilets seize up. We replace them with new quarter-turn valves and fresh supply lines.
Sink and vanity installation
New sinks, vanities, and kitchen faucets set level, sealed, and connected to working shutoffs. We check the drain trap and the supply lines before we call it done.
Keep the old faucet, or put in a new one?
If parts are available and the body is in good shape, a repair is usually fine. If the finish is pitted, the valve body is cracked, or you’ve repaired the same faucet twice, it’s time for a new one. And if the drip or low flow comes from the pipe behind the wall, we’ll show you and talk about pipe repair instead.
If a valve is stuck open or a supply line has burst under a sink, call us at (726) 227-0988 and close the main.
Checks you can safely make
- Try closing the shutoff valve under the sink or behind the toilet. If it spins or won’t move, leave it and close the main instead.
- Unscrew the faucet aerator and rinse out any grit if the flow is weak.
- With a toilet that keeps refilling, take the lid off and watch whether the rubber flapper drops flat and seals.
Faucet and toilet installation cost in Universal City
Fixture prices in Universal City vary with the faucet or toilet you choose and with the condition of the shutoff, flange, or supply line behind it.
| Service | Typical cost in Universal City |
|---|---|
| Faucet repair | $125 to $300 |
| Faucet replacement | $150 to $400 |
| Toilet repair | $125 to $350 |
| Toilet installation | $250 to $700 |
| Shower valve or cartridge work | $200 to $600 |
These figures are typical ranges for Universal City and the San Antonio area, not a final bill. The final price depends on the problem, the parts, how hard the work is to reach, and whether the call is after hours. We diagnose on site and give you the number before any repair starts.
Compare these figures with the full list on our plumbing cost in Universal City page, or call (726) 227-0988.
Faucet, toilet, and shower valve questions
My toilet is new, so why does it wobble when I sit down?
The flange underneath may be broken, set too low, or the floor may not be level. Shims and a new wax ring hide the problem for a while. Fixing the flange solves it.
Why is my faucet still dripping after I changed the handle?
The handle only turns the cartridge. The drip comes from a worn cartridge or seat inside, which is often scaled up from the hard water.
When does a shower valve need to be replaced behind the wall?
When the cartridge is no longer made, the valve body is cracked, or temperature swings keep happening after a new cartridge. We’ll check before cutting any tile.
Can you set a new toilet on an older flange?
Often, yes. If the flange is cracked or too low, we repair it so the new toilet seals and sits solid.
How much does it cost to install a new faucet in Universal City?
Faucet replacement typically runs $150 to $400 depending on the faucet and the condition of the shutoff valves and supply lines behind it. The final price depends on what we find once the old faucet comes off.
Why does my bathroom faucet handle feel stiff or hard to turn?
Universal City’s hard water leaves mineral buildup inside the cartridge and valve body. Over time this scale makes handles stiff and can cause early drips. A cartridge replacement usually fixes it.
Can a plumber replace a toilet without replacing the flange?
Often, yes, if the flange is solid and at the right height. If it is cracked, corroded, or sits too low, we repair the flange first so the new toilet seals properly.
Do I need a plumber to install a new bathroom sink or vanity?
Yes, especially if the drain trap, supply lines, or shutoff valves need to be reconnected or replaced. We set the sink level, confirm a solid seal, and check that the shutoffs work before finishing the job.
Fixtures that work like they should
Our plumbers in Universal City repair and install faucets, toilets, sinks, and shower valves. Call (726) 227-0988 for fixture work in Universal City. You can also browse our plumbing services, read who we are, check the FAQ, or use our contact page.
Service ZIP: 78148
Plumbing Problem? Call Universal City Plumbing Solutions Today
